Dana Lim - DanAtac Vinyl 246

€64.16
€107.01
You save: €42.85

With heavy wet scrub and extended reactivation capability

Model: 4203
Weight: 16,5
Availability: In stock

Product description & application:

DanAtac Vinyl 246, is a fast specific water-based adhesive, with a strong wet seal, completely free of organic solvents. The glue has a short open time and can be used both for wet and adhesive bonding. Furthermore, the glue has an excellent reactivation ability. Used for bonding homogeneous vinyl, vinyls with foam or tissue backing, rubber or e.g. linoleum with oleofin foam backing on absorbent and non-absorbent surfaces. Is also suitable for setting up wall wine bottles.

 

Physical / chemical data:

Content: 10 liters

Type: Water-based co-polymer dispersion

Color: Light beige

Consistency: Pastous, thixotropic

Solids content: approx. 74%

Density: approx. 1.38 kg / liter

Shelf life: Minimum 12 months in unopened packaging for cool storage. Store frost-free

Instructions for use :

Preparation: The glue is stirred before use. Glue and coating are tempered before use at between 18 ° C and 25 ° C, corresponding to the floor temperature. The moisture percentage in the subfloor must be max. be of size determined for the coating concerned (85 - 90% RH, depending on material). Moisture measurement must be carried out in accordance with GSO Gulvfakta's rules. Possibly moisture insulation must be done. Bonding can be done on all smooth, flat and sustained dry substrates such as concrete, wood fiber boards and cement putty joints. Always follow the coating supplier's instructions. For underfloor heating, special precautions must be taken, see the coating supplier's instructions. For light vinyl coatings, discoloration of the vinyl material may occur. We recommend doing a test in these cases. Floor tile primers are primed with Primer 600 diluted with water, in a ratio of 1: 5. Anhydrite substrate is primed twice with Primer 600 diluted with water. First time 1: 5, second time 1: 3. The primer should be completely dry before application.

Application temperature: 18 ° C to 25 ° C. The relative humidity in the room must not exceed 65%. The humidity can possibly reduced by air heating and / or ventilation. Glue amount & method: 4-5 m2 / liter (for rubber recommended 3½-4 m2 / liter).

Bonding: The glue is applied to the substrate with a toothpick. The coating is mounted in the wet glue and rubbed carefully into place, then the coating is lifted so that the glue is aired for 5-10 minutes, after which the coating is carefully rubbed into place. Druming of the coating after application is always recommended.

Finishing: When gluing in wet rooms, all joints must be sealed.

Reactivation: The cured glue can be reactivated at high heat from a heat gun for 30-60 sec. in the area in question, after which it is possible to smooth out possibly. bumps or bumps. After cooling, the glue has resumed its thanks and strength. The glue can be reactivated over a longer period.

Cleaning: Remove skin from the skin with soap and water. Tools are cleaned with warm water while the glue is still wet. Dried glue dissolves with alcohol.