Danalim D2 Wood Glue - 750 ml.
Wooden glue D2 Inside 490
Wood Glue D2 Inside 490 is a fast-limiting and strong all-round PVAc glue for most indoor wood glue.
Used for joints, lamination and edge bonding (wood, laminate, veneer etc.).
Wooden glue D2 Inside 490 is suitable for both cold and hot press and high frequency (HF) bonding. The adhesive is moisture resistant according to EN 204/205, class D2.
Preparation: The adhesive surfaces must be well-adapted, clean and dry, free of oil, grease and the like. Best result is obtained on newly processed wood.
Application: Apply the adhesive to one surface. When bonding hard wood species, it is advantageous to apply glue to both surfaces and increase the waiting time and the pressing time.
Wood humidity: Best from approx. 7 - 15%.
Application temperature: Min. 10 ° C. The temperature applies to wood, glue and room.
Open waiting time: Max. 5 minutes on pine wood at 20 ° C and 50% humidity. When merging, the glue must always give full contraction on the opposite surface. If the waiting time is "closed", it can be increased by approx. 1 - 2 minutes. The waiting time can be extended by double glue application, hard wood, lower temperature and higher air / wood humidity. The wait time is reduced at higher temperature and lower air / wood humidity. Pressure: Approx. 1 - 5 kg / cm². For stresses in the wood, higher pressures are required.
Press Time: Min. 6 minutes for pine with approx. 9% wood moisture at 20 ° C. The pressing time must be increased by hard wood, double glue application, lower temperature and higher wood and air humidity. The press time can be reduced by e.g. preheating of the wood or use of hot press. Full strength is achieved after approx. 1 day at 20 ° C. Cleaning: Remove skin from the skin with soap and water. Tools are cleaned with water while the glue is still wet. Dried glue dissolves with alcohol.