Product description & use:
DanAtac Linoleum XL 257, a special product developed for e.g. linoleum. The glue has a particularly strong wet cut and enormous strength. The glue has an extra long open time and can be used for both wet and tack gluing. Furthermore, the glue can be reactivated when exposed to heat. DanAtac Linoleum XL 257 is a water-based dispersion adhesive, and thus completely free of organic solvents. Used for gluing linoleum on absorbent and weakly absorbent substrates such as concrete, wood fiber boards and cement putty. The glue is also suitable for wet gluing of e.g. carpets with or without latex backing.

Physical / chemical data:
Contents: 10 litres
Type: Water-based co-polymer dispersion
Colour: Light beige
Consistency: Pasty, thixotropic
Dry matter content: approx. 75%
Density: approx. 1.38 kg/litre
Shelf life: Minimum 12 months in unopened packaging when stored cool. Store frost-free

Instructions for use:
Preparation: Stir the glue before use. Before use, glue and coating are tempered to between 18 °C and 25 °C, corresponding to the floor temperature. The moisture percentage in the subfloor must be max. be of the size determined for the covering in question (85% RH, for linoleum). Moisture measurement must be carried out according to GSO Gulvfakta's rules. If necessary, moisture insulation must be provided. Gluing can be done on all smooth, flat and continuously dry surfaces such as concrete, wood fiber boards and cement putty. Always follow the coating supplier's instructions. With underfloor heating, special precautions must be taken, see the coating supplier's instructions. Substrates of floor putty are primed with Primer 600 diluted with water, in a ratio of 1:5. Substrates of anhydrite are primed twice with Primer 600 diluted with water. First time 1:5, second time 1:3. The primer must be completely dry before applying glue.
Application temperature: 18 °C to 25 °C. The relative humidity in the room must not exceed 65%. The humidity may possibly reduced by air heating and/or ventilation.
Amount of glue & method: The recommended amount of glue depends on the type of coating. Linoleum: 3 – 4 m²/litre
Carpets: 4 - 5 m²/litre
Gluing: The glue is applied to the substrate with a notched trowel. The coating is mounted in the wet glue and carefully rubbed into place, if the curing time is further shortened, air the coating for 5-10 minutes, after which it is again carefully rubbed into place. Drumming the coating after application is always recommended.
Finishing: Joints are sealed as recommended by the coating supplier or as specified in GSO Gulvfakta.
Reactivation: The hardened glue can be reactivated by high heat from a heat gun for 30-60 seconds. in the area in question, after which it is possible to smooth out any dents or irregularities. After cooling, the glue has regained its tack and strength. The glue can be reactivated over a longer period of time.
Cleaning: Glue on the skin is removed with soap and water. Tools are cleaned with warm water while the glue is still wet. Dried glue dissolves with alcohol.

Download:
Safety sheet