Product description & use: Floor & Wall Glue 245 Ekspres, is a fast all-round water-based glue, with a strong wet tack, completely free of organic solvents. The glue has a short opening time and can be used for both wet and tack gluing. Used for gluing homogenous vinyl, vinyls with foam or tissue backing, cork with PVC backing, needle felt, coir carpets with or without backing, carpets with latex or PVC backing on absorbent and non-absorbent substrates. Is also suitable for setting up wall vinyls.

Physical / chemical data:
Contents: 1 litre, 5 liters and 10 litres
Type: Water-based co-polymer dispersion
Colour: Light yellow
Consistency: Pasty, thixotropic
Dry matter content: approx. 75%
Density: approx. 1.3 kg/litre
Shelf life: Minimum 12 months in unopened packaging when stored cool. Store frost-free.

Instructions for use:
Preparation: Stir the glue before use. Before use, glue and coating are tempered to between 18 °C and 25 °C, corresponding to the floor temperature. The moisture percentage in the subfloor must be max. be of the size specified for the coating in question (85 - 90% RH, depending on material). Moisture measurement must be carried out according to GSO Gulvfakta's rules. If necessary, moisture insulation must be provided. Gluing can be done on all smooth, flat and continuously dry surfaces such as concrete, wood fiber boards and cement putty. Always follow the coating supplier's instructions. With underfloor heating, special precautions must be taken, see the installation supplier's instructions. Substrates of floor putty are primed with Primer 600 diluted with water, in a ratio of 1:5. Substrates of anhydrite are primed twice with Primer 600 diluted with water. First time 1:5, second time 1:3. The primer must be completely dry before applying glue.
Application temperature: 18 °C to 25 °C. The relative humidity in the room must not exceed 65%. The humidity may possibly reduced by air heating and/or ventilation.
Amount of glue: Vinyl floor: 4-5 m2/litre - Needle felt & carpets: 2-5 m2/litre
Wet gluing: The glue is applied to the substrate with a notched trowel. The coating is mounted in the wet glue. If a more powerful tack is desired, you can wait with laying down for approx. 5 - 15 minutes. Late wet gluing can be done up to approx. 20 minutes after glue application. However, the glue must still feel wet, and give a smear on the back of the coating. The coating is carefully rubbed in with a suitable tool.
Adhesive bonding: The glue is applied to the substrate with a notched trowel. The coating is mounted in the wet glue and carefully rubbed into place, then the coating is lifted so that the glue is aired for 5-10 minutes, after which the coating is carefully rubbed into place. Drumming the coating after application is always recommended.
Finishing: When gluing in wet rooms, all joints must be sealed.
Cleaning: Glue on the skin is removed with soap and water. Tools are cleaned with water while the glue is still wet. Dried glue dissolves with alcohol.

Download:
Safety sheet